Labelling
Labelling internal battery GEB461
Labelling GKL311
Labelling GKL341
TS20 Frequency bands, output power: Depending on regional regulatory requirements, the output power may be lower or some frequency bands may not be available 
GMI01 Frequency bands, output power: Depending on regional regulatory requirements, the output power may be lower or some frequency bands may be not available 
SAR values 
EU 
UK: Hereby, Leica Geosystems AG declares that the radio equipment type TPS1 is following the provisions of the applicable relevant statutory requirement S.I.
2017 No. 1206 Radio Equipment Regulations 2017.
USA:
FCC ID: RFD-BELUGA
Part 2, 15 B/C/E, 22, 24, 27, 90
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference
that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, it may cause harmful interference to radio communications.
However, there is no guarantee that interference does not occur in a particular
installation
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by Leica Geosystems for
compliance could void the user's authority to operate the equipment.
Responsible Party – U.S. Contact Information
Michael Harvey
Leica Geosystems, Inc.
10035 Via Colomba Cir #205
Fort Myers, FL 33966, USA
Tel.: (615) 585-0689
Email: michael.harvey@leicaus.com
Canada
CAN ICES-003(B)/NMB-003(B)
IC: 3177A-BELUGA
Canada Compliance Statement
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licenceexempt RSS(s). Operation is subject to the following two conditions:
1. This device may not cause interference
2. This device must accept any interference, including interference that
may cause undesired operation of the device
Canada Déclaration de Conformité
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et Développement
économique Canada applicables aux appareils radio exempts de licence.
L’exploitation est autorisée aux deux conditions suivantes:
1. L’appareil ne doit pas produire de brouillage
2. L’appareil doit accepter tout brouillage radioélectrique subi, même si
le brouillage est susceptible d’en compromettre le fonctionnement du
dispositif
Taiwan
Hexagon Geosystems (Taiwan) Co., Limited
10F-2, No.150, Fuxing N. Rd., Zhongshan Dist., 10487 Taipei, Taiwan
Others: The conformity for countries with other national regulations has to be
approved prior to use and operation.