Adjust height of an electric mast: If you operate your machine with an electrical mast in a TPS setup, you may need to adjust mast height. This workflow describes how to adjust the height in the 2D system.
Your 2D solution
Workflows in this chapter focus on your 2D machine control solution. 
2D solution content:
• Workflow 01: Switch from 3D to 2D mode
• Workflow 02: Operate your machine with "cross slope" only
• Workflow 03: Sonic Tracer Considerations
• Workflow 04: Operate your machine with "Sonic tracer"
• Workflow 05: Laser setup considerations
• Workflow 06: Set up a laser to create dual sloping surfaces
• Workflow 07: Operate your machine with laser receiver + cross slope
• Workflow 08: Operate your machine with "dual" laser receivers