If you operate your machine with an electric mast in a TPS setup, you may need to adjust mast height. This workflow describes how to adjust the height in the 2D system.
Your 2D solution: Workflows in this chapter focus on your 2D machine control solution. 
2D solution content:
• Workflow 01: Switch from 3D to 2D mode
• Workflow 02: Operate your machine with "cross slope" only
• Workflow 03: Operate your machine with "CoPilot"
• Workflow 04: Understanding CoPilot modes
• Workflow 05: Laser setup considerations
• Workflow 06: Set up a laser to create dual sloping surfaces
• Workflow 07: Operate your machine with laser receiver + cross slope
• Workflow 08: Operate your machine with "dual" laser receivers
• Workflow 09: Configure sensor position without the MJB130x junction box