Skip to content
English
Go to ABTECH.com
  • There are no suggestions because the search field is empty.

Installation on a Machine 3.9

☞ In general, all installation works must be done by a dedicated installation specialist. Please contact the local selling unit or dealer for further information. The installation information within this User Manual is indicated to increase the operators understanding of the system and its maintaining.

☞ Before installation:
• Please observe the maximum vibration and ambient temperature values indicated in chapter 9 Technical Data.
• Check that all parts needed are delivered. Refer to 2.2 Unpacking the Container for further information.
• It is strongly recommended that you bench test all components before commencing installation on the actual machine to make sure that all components are fully operational.

iCON gps 60 SmartAntenna Installation location: The iCON gps 60 SmartAntenna must be installed in the machine cabin itself. For easy mounting the optional Machine Bracket CMB3 is recommended.

☞ The product must not be installed on the tool of the machine and/or on mechanical components that move the tool. Tools include for example bucket of excavator, blade of dozer, screed of paver. Mechanical parts include for example boom and stick of an excavator,
hydraulic cylinder of a dozer or tow arm of an asphalt paver. Further, the instrument must not be installed near chassis, chain gear, wheels or on engine components connected to the engine
itself. The cases stated are intended simply as examples. 

Installation of a CGA100 GNSS antenna: For best results, it is recommended to mount the GNSS antenna in a way ensuring an unobstructed view of the sky.

Installation of external radio: A special bracket for proper mounting of the external GFU radio can be used. GFU bracket: MMB1250, GFU Bracket on Machine

Installation of antennas for internal/external radios

• External antennas with a magnetic mount can be used and installed on the roof of the cabin.
• This will increase the radio signal and therefore the reception of correction signals from a base station. 

Cable installation 

• Ensure that the cables between iCON gps 60 SmartAntenna and CGA100 antenna in particular are installed so as to prevent them from becoming bent and stretched.
• It is strongly recommended to use strain relief brackets.
• Route the cable as directly as possible and avoid crossing cables.
• Be sure not to tie the cables into “hot” hydraulic hoses.