Labelling
Labelling
Labelling
EU
Hereby, Leica Geosystems AG declares that the radio equipment type iCS20/iCS50 is in compliance with Directive 2014/53/EU and other applicable European Directives. The full text of the EU declaration of conformity is available at the following Internet address: http://www.disto.com/ce.
UKCA
Hereby, Leica Geosystems AG declares that the radio equipment type iCS20/ iCS50 is following the provisions of the applicable relevant statutory requirement S.I. 2017 No. 1206 Radio Equipment Regulations 2017. The full text of the UK declaration of conformity is available at the following Internet address: http://www.disto.com/ukca.
USA
Contains FCC ID: PPD-QCNFA324
Class B
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, it may cause harmful interference to radio communications.
However, there is no guarantee that interference does not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by Leica Geosystems for compliance could void the user's authority to operate the equipment.
Canada
CAN ICES-003 Class B
IC: 4104A-QCNFA324
Canada Compliance Statement
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada’s licenceexempt RSS(s). Operation is subject to the following two conditions:
1. This device may not cause interference
2. This device must accept any interference, including interference that may cause undesired operation of the device
Canada Déclaration de Conformité
L’émetteur/récepteur exempt de licence contenu dans le présent appareil
est conforme aux CNR d’Innovation, Sciences et Développement économique
Canada applicables aux appareils radio exempts de licence. L’exploitation est
autorisée aux deux conditions suivantes:
1. L’appareil ne doit pas produire de brouillage
2. L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement du dispositif
Radio Frequency (RF) Exposure Compliance Statement
The radiated RF output power of the instrument is below the Health Canada’s Safety Code 6 exclusion limit for portable devices (radiated element separation distance between the radiating element and user and/or bystander is below 20 cm).
Japan
• This device is granted pursuant to the Japanese Radio Law (電波法).
• This device should not be modified (otherwise the granted designation number will become invalid).
Brazil
This equipment is not entitled to protection against harmful interference and may not cause interference to duly authorised systems.
This equipment is not suitable for use in domestic environments, as it may cause electromagnetic interference that requires the user to take necessary measures to minimize this interference.
For more information, see the ANATEL website: http://www.anatel.gov.br/
Mexico
The operation of this device is subject to the following two conditions:
1. This device may not cause interference
2. This device must accept any interference, including interference that may cause undesired operation of the device
Others
The conformity for countries with other national regulations has to be approved prior to use and operation.