Step-by-step
Take the DS4000 out of the Card box or the Hard shipping box, if purchased.
1. Remove the pins fastening the rudder on top of the “U-frame”.
2. Unfold the rudder upward, by holding the handle.
3. Lean the horizontal bar of the rudder against the “U-frame” to support the rudder itself.
4. a) Enter the two pins inside the two holes on the side of the rudder, next to the horizontal bar.
b) Fasten the rudder against the “U-Frame”.
5. Place the DS4000 antenna on the floor, before the cart, and choose the polarization (orientation) of the antenna:
• Polarization HH (left image)
LAN and wheel connector towards the front of the system or towards the operator
• Polarization VV (right image)
LAN and wheel connector towards the left (or right) side of the operator
6. Place the DS4000 cart on top of the antenna (HH-oriented in the image).
7. Enter the four antenna belts into the four holes at each corner of the cart.
8. Fix the antenna belts to the four pins on top of the cart. Six slots are available on each belt. The height of the bottom of the antenna from the ground depends on the slot used to fix the antenna to the cart.
9. Plug the wheel cable into the wheel connector on top of the antenna.
10. Plug the LAN cable into the LAN connector on top of the antenna.
11. Open the battery compartment and enter the battery.
12. Attach the clamp for the tablet holder on the square bar on top of the rudder and attach the tablet holder.
13. Place the tablet on the tablet holder and plug the LAN cable to the LAN port.
14. The setup is completed. No field PC is shown.